Leg Assembly

1.Lay right side panel (#2) face down on a soft surface to avoid marking finish. Attach three brackets with 1/2" screws to bottom of right front leg (#3) leaving screws slightly loose. Face brackets out toward tongued side

(see Figure 1). Place right front leg over right side (#2) matching groove in leg to tongue on side, as shown in

Figure 1, matching trim on side with trim on front. Align threaded holes with brackets on side. Start three 1/2" screws through brackets. Align bottom of side and leg assembly so they are flush with each other. Hold these pieces securely in alignment while tightening (but not over tightening) screws.

2.Assemble left side (#4) and left leg (#5) as described in step 1.

3.Attach 6 brackets to base (#1) at threaded hole locations using 1/2" screws leaving screws loose. Face brackets toward outside.

4.Place right side/leg assembly on base and align threaded holes with brackets. Start 1/2" screws through brackets into threaded holes in side/leg assembly. Back of side/ leg assembly should be flush with back of base. Assure alignment is correct and spaces are at a minimum. Leave screws slightly loose.

 

Tongue on

 

Leg Side

Leg Side (#4) 1/2" Screw

 

Bracket

 

 

Leg Front (#5)

 

Groove in

Groove in

Leg Front

Leg Front

 

Leg Front (#3)

 

5.Assemble left side/leg assembly to base (#1) following step #4.

Right

Side/Leg

Assembly

Base (#1)

Bracket

1/2" Screw

Figure 2 - Leg Assembly to Base

Header Assembly

1.Using 1/2" screws, secure brackets to two threaded holes at both ends of header (#6). Turn brackets to the outside.

2.Place header extension (#6A) onto bottom edge of header aligning holes in extension with threaded holes in header

(see Figure 3). Using two 1 1/4" screws with washers and Allen wrench provided, attach extension to header but do not completely tighten screws.

Tongue on

Leg Side (#2)

Leg Side

Bracket

1/2" Screw

Header (#6)

Figure 1 - Right and Left Leg Assemblies

1 1/4"

 

Screw

Header

with

Washer

Extension (#6A)

Figure 3 - Attaching Header Extension

2

www.desatech.com

119494-01C