
3.Place header assembly into position on top of leg as- semblies with arrow pointing up. Bottom of header will slide in behind upper portion of leg front panels and rest on shoulders (see Figure 4). Align bracket holes with threaded inserts in leg assemblies. Using four 1/2" screws through brackets, attach header to leg assemblies. Leave screws loose.
4.Using two 1 1/4" screws with washers, attach header extension to leg assemblies as shown in Figure 3, page 2, but do not tighten.
Header (#6) with
Extension (#6A)
Threaded
Insert
Bracket
1/2" Screw
Shoulder of
Leg Front
Panel
Place mantel top (#7) on mantel assembly. Align back of top with back of sides. Using four 1 1/4" screws with washers, place two in each mantel side assembly (see Figure 5). Using three 1 1/4" screws with washers, attach top to header.
Mantel Top (#7)
Washer
1 1/4"
Screw
Mantel Side
Assembly
Figure 5 - Attaching Mantel Top
Finishing MantelStarting with left side leg assembly and with one person holding parts in alignment, tighten screws using Allen wrench provided. Tighten screws on the right side leg assembly, header extension, header, top assembly and base.
Figure 4 - Installing Header Assembly
Gas Fireplace Installation
1.Fireplace should be fully assembled. See Assembling Fireplace in fireplace owner’s manual.
2.Place mantel base close to installation location. See fire- place owner’s manual for installation clearances. Leave enough room to insert fireplace from back of mantel.
3.Install gas line. See Connecting to Gas Supply in fireplace owner’s manual. Remember to leave access to the gas shutoff valve somewhere on the base or where it is ac- cessible to the user.
4.Check for leaks. See Checking Gas Connections in fire- place owner’s manual.
www.desatech.com | 3 |