Desa W32LT Assembling Perimeter Trim (If Supplied, with Gas Fireplace), Fireplace with louver door:, Fireplace with fixed louver: Before installing logs or

5. Position fireplace inside mantel (see Figure 6). Care-

fully position gas lines. Important: Use caution when

positioning fireplace on base. Base may scratch easily.

Make sure fireplace is in proper position within mantel

opening before continuing with installation.

6. Fireplace with louver door: Lower bottom louver door.

Use two screws provided in hardware package and attach

fireplace to wooden base. Close louver door

Fireplace with fixed louver: Before installing logs or

burner assembly (see owner’s manual) remove screws

securing floor to assembly. Lift floor for access to bot-

tom of fireplace. Use two screws provided in fireplace

hardware package and attach fireplace base to wooden

base. Reinstall floor with screws removed previously.

7. If mantel trim that came with your fireplace has not yet

been assembled, see Assembling Perimeter Trim. Place

metal trim on shoulder screws. Firmly snap trim assembly

over shoulder screws on fireplace.

with Gas Fireplace)

1.Remove packaging from three pieces of metal trim.

2.Locate two adjusting plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 7.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 7).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 7).

6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screw- driver.

7.Repeat steps 2 through 6 for other corner.

Slot

Set Screws

8. Carefully push mantel and base into position against

wall.

Adjusting Plate

Top Trim

Mitered Edge

Shim

Side Trim

Slot

Figure 7 - Assembling Trim

Figure 6 - Installing Fireplace