Design Dynamics VTD-18N-PDG To Turn OFF GAS To Appliance, Manual Lighting Procedure, Operation

Operating Heater

Continued

WARNING: Make sure selec- tor switch is in to OFF position when you are away from home for long periods of time. Appli- ance will come on automatically with selector switch in the ON position.

Propane/LPNatural

Figure 12 - Pilot (Remote Shown)

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater

1. Turn control knob clockwise to the OFF position.

2a. Set selector switch in the OFF position.

2b. If Using Optional Hand-Held Remote: Set selector switch in the OFF position to prevent draining battery.

Shutting Off Burner Only (pilot stays lit) You may shut off the burners and keep the pilot lit by doing one of the following:

1.Turn control knob clockwise to the PILOT position.

2.Use remote control manual OFF button.

3.Set selector switch in the OFF position.

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, page 16.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, Lighting Instructions, page 17.

Optional Hand-held

REMOTE control

OPERATION

1.After lighting, let pilot flame burn for about one minute. Turn control knob to

ON position. Adjust flame adjustment knob anywhere between HI and LO. Set toggle selector switch to AUTO. Slide remote selector switch to REMOTE position (see Figure 13). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand- held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

2.Press ON/OFF button to turn burners on and off. When turning burners off, the pilot will remain lit.

IMPORTANT: Be sure to press ON/OFF buttons on hand-held remote control unit for up to 3 seconds to assure proper operation.

Control Knob				Remote Selector
				Switch
		OL	AUTO
N
	O		OFF
O	F
T		HI		OFF REMOTE ON
	F		ON
OLIP
Ignitor		Flame		Selector Switch
		Adjustment
Button				in AUTO Position
		Knob

Figure 13 - Control Knob and Ignitor Button Locations for Remote Control

Remote Control Specifications

Batteries: (See instructions with remote for removing and installing batteries) Transmitter requires 12V (A-23) and 3V button cell for LCD (both included)

Remote receiver requires 4 AA (1.5V) alkaline batteries (included)

Operating Frequency: 303.875 MHz

12 www.desatech.com 111826-02J