APPLICATION OF LIQUID VEHICLE WAX
1.Immediately after cleaning, apply Pressure Washer Liquid Vehicle Wax using low pressure. Pour wax into chemical solution reservoir.
2.Apply the wax sparingly in an even layer. Apply to wet surfaces from the bottom up for even distribution and to avoid streaking.
3.Rinse off the surplus wax. NOTE – IF SURPLUS WAX IS NOT REMOVED, A HAZY FINISH MAY RESULT.
4.Wipe dry to reduce water spotting.
4.7END OF OPERATION
When you have completed use of the chemical injection system, remove tube from container, continue to run in low pressure position and flush clean water through the chemical tank until it is thoroughly cleaned. NOTE: Failure to clean properly will cause the injection system to become clogged and inoperable.
λStop the unit by pressing the ON/OFF button to the "OFF" position.
λDisconnect electrical plug.
λTurn off water and depressurize unit by squeezing trigger.
Turn off water supply and squeeze trigger to depressurize the unit. Failure to do so could result in personal injury due to discharge of high pressure water.
λDisconnect the high pressure discharge hose and the water inlet hose.
5.0MAINTENANCE
5.1CONNECTIONS
Connections on Pressure Washer hoses, gun and spray wand should be cleaned regularly and lubricated to prevent leakage and damage to the
5.2NOZZLE
The high pressure/low pressure adjustment of the nozzle should be lubricated regularly.
Clogging of the nozzle causes the pump pressure to be too high and cleaning is immediately required.
1. Separate the nozzle from the wand
2. | Clear the nozzle. |
3.Flush the nozzle backwards with water
4.Reconnect the nozzle to the wand
NOTE: Completely screw the nozzles on the wand up to the complete lock. (see picture)
Restart the pressure washer and depress the trigger on the spray gun. If the pressure is still too high, repeat above items
D28921 | 14- ENG |
