DeVillbiss Air Power Company WD1600E, D28921 Operating Instructions, Start-Up Procedure

Models: D28921 WD1600E

1 60
Download 60 pages 11.04 Kb
Page 10
Image 10
4.0OPERATING INSTRUCTIONS

A.Connect only to properly grounded outlet. Do not remove grounding pin.

B.Inspect cord before using. Do not use if cord is damaged.

C.Keep all connections dry and off the ground.

D.Do not touch plug with wet hands.

E.The pressure washer is provided with a ground-fault circuit interrupter built into the power plug. If replacement of the plug or cord is needed, use only identical replacement parts. Contact Customer Service for proper replacement parts.

Extension cords are not recommended unless they are plugged into a receptacle protected by a ground fault circuit interrupter. Any extension cord used should be 14 AWG and no longer than 50 feet to prevent excessive voltage loss. Use only extension cords intended for outdoor use. These extension cords are identified by a marking “Acceptable for use with outdoor appliances; store indoors when not in use”.

4.0OPERATING INSTRUCTIONS

4.1START-UP PROCEDURE Risk of injection or injury. Do not direct discharge stream at persons.

4.1START-UP PROCEDURE

1.Make sure water supply is connected and turned on.

2.Make sure the unit is plugged in and the GFCI HAS BEEN RESET.

3.Release gun safety if locked.

A.

Safety lock “locked”

B.

Safety lock “unlocked”

4.To allow air to escape from the hose, squeeze trigger on the gun until there is a steady stream of water.

5.Remove any dirt or foreign matter from the gun outlet and the male connector of the wand.

6.Insert the requested wand into the gun’s quick connect coupling by pushing firmly and twisting wand ¼ of a turn to lock into place.

NOTE: Make sure wand is locked.

D28921

10- ENG

Page 10
Image 10
DeVillbiss Air Power Company WD1600E, D28921 Operating Instructions, Start-Up Procedure, NOTE Make sure wand is locked