DeVillbiss Air Power Company XC2800, A20118 operation manual Washer, Spray Pattern Uses, Surfaces

	0º	15º		40º		Soap
Spray Pattern
Uses	powerful		intense		intense	applies
	pinpoint for		cleaning of		cleaning of	cleaning
	very intense		small areas		larger areas	solutions
	cleaning
Surfaces *	Metal or		metal,		metal,	metal,
	concrete		concrete, or		concrete, or	concrete,
	DO NOT use		wood		wood	wood, or vinyl
	on wood

* The high pressure spray from your pressure washer is capable of causing damage to surfaces such as wood, glass, automobile paint, auto striping and trim, and delicate objects such as flowers and shrubs. Before spraying, check the item to be cleaned to assure yourself that it is strong enough to resist damage from the force of the spray.

To reduce the risk of injury, read the pressure washer instruction manual and the engine instruction manual before starting pressure

washer.

Risk of fluid injection and laceration. When using the high-pressure setting, DO NOT allow the high-pressure spray to come in contact

with unprotected skin, eyes, or with any pets or animals. Serious injury will occur.

•Your washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fittings or worn or damaged hoses can result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!

Risk of Fire, Asphyxiation and Burn. NEVER fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.

•NEVER fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below bottom of filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine.

•NEVER run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.

•DO NOT let hoses come in contact with very hot engine muffler during or immediately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.

Risk of property damage. NEVER pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.

•DO NOT use hot water, use cold water only.

•NEVER turn water supply off while pressure washer engine is running or damage to pump will result.

•DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged.

If you do not understand these precautions, please call 1-800-888-2468 to speak to a service representative for further instructions.

A20118 12- ENG