HOW TO CLEAN THE WATER INLET FILTER

This screen filter should be checked periodically and cleaned if necessary.

2.Clean filter by flushing it with water on both sides.

3.Re-insert filter into water inlet of pump. NOTE: Cone side faces out.

1.Remove filter by grasping end and removing it from water inlet of pump as shown.

Filter Screen

NOTE: Do not operate pressure washer without filter properly installed.

STORAGE

ENGINE

Consult the Engine Owners Manual for the manufacturer's recommendations for storage.

PUMP

The manufacturer recommends using a pump protector/winterizer, such as DEWALT DP80, when storing the unit for more than 30 days and/or when freezing temperatures are expected. If a pump protector/winterizer is not available, RV antifreeze or windshield washer fluid needs to be run through the pump as outlined in the steps below.

NOTE: Using a pump protector/ winterizer, RV antifreeze or windshield washer fluid is to provide proper lubrication to the internal seals of the pump regardless of temperature or environment.

1.Obtain a funnel, 6 oz. of RV antifreeze or windshield washer fluid, and 16–36" (40.6 to 95 cm) of garden hose with a male hose connector attached to one end.

Risk of property damage. Use only

RV antifreeze. Any other antifreeze is corrosive and can damage pump.

2.Disconnect spark plug wire.

3.Connect length of garden hose to water inlet of pump.

4.Add RV antifreeze or windshield washer fluid to hose as shown.

5.Pull engine starter rope slowly several times until antifreeze/ washer fluid comes out of high- pressure hose connection of pump.

6.Remove garden hose from water inlet of pump.

A20118

16- ENG

Page 16
Image 16
DeVillbiss Air Power Company XC2800, A20118 operation manual Storage, Clean filter by flushing it with water on both sides