DeWalt D2002M instruction manual Extension Cords under Installation

Code	possible cause	POSSIBLE SOLUTION
15	Extension cord is wrong length or gauge	Check for proper gauge wire and cord length. See
		Extension Cords under Installation.
16	Loose electrical connections	Contact a DeWALT factory service center or a DeWALT
		authorized service center.
17	Possible defective motor.	Contact a DeWALT factory service center or a DeWALT
		authorized service center.
18	Fuse blown, circuit breaker tripped	1.	Check fuse box for blown fuse and replace as necessary.
			Reset circuit breaker. Do not use a fuse or circuit
			breaker with higher rating than that specified for your
			particular branch circuit.
		2.	Check for proper fuse. Use only a time delay fuse.
		3.	Check for low voltage conditions and/or proper extension
			cord.
		4.	Disconnect the other electrical appliances from circuit or
			operate the compressor on its own branch circuit.
19	Tank pressure exceeds pressure switch cut-inpressure	Motor will start automatically when tank pressure drops
		below cut-inpressure of pressure switch.

English

17