DeWalt D2002M instruction manual Features, For Future USE

English

WARNING: Risk of FALLING

What can happen How to prevent it

Features

On (I) /Off Switch (O)
Place this switch (A) in the ON position to provide
automatic power to the pressure switch and	A
OFF to remove power at the end of each use.

•A portable compressor can fall from a table, workbench, or roof causing damage to the compressor and could result in serious injury or death to the operator.

•Always operate compressor in a stable secure position to prevent accidental movement of the unit. Never operate compressor on a roof or other elevated position. Use additional air hose to reach high locations.

Pressure Switch (not shown)

The pressure switch automatically starts the

motor when the air tank pressure drops below

the factory set cut-inpressure. It stops the motor when the air tank pressure reaches the factory set cut‑out pressure.

Safety Valve

If the pressure switch does not shut off the air compressor at its cut-out pressure setting, the safety valve (F) will protect against high pres- sure by popping out at its factory set pressure

CAUTION: risk from noise

What can happen How to prevent it

(slightly higher than the pressure switch cut-out setting).

•Under some conditions and duration of use, noise from this product may contribute to hearing loss.

•Always wear proper hearing protection during use.

Check Valve

When the air compressor is operating, the check valve (I) is open, allowing compressed air to enter the air tank. When the air compressor

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

reaches cut-out pressure, the check valve closes, allowing air pressure to remain inside the air tank.

8