DeWalt D25851K Active Vibration Control Fig, Inserting and Removing Spline Drive Accessories Fig

Models: D25851K

1 44
Download 44 pages 17.54 Kb
Page 34
Image 34

English

FIG. 2

M

FIG. 3

I

 

 

 

K

 

 

 

N O

P L

J

H

C

C

TO MOUNT IN FRONT POSITION (FIG. 2)

1.Unscrew the side handle (C) and disassemble the side handle clamp (J).

2.Snap the steel ring (K) over the collar (L) behind the tool holder

(M). Squeeze both ends of the steel ring together. Mount the bushing (N) and insert the pin (O).

3.Slide the side handle clamp (J) over the bushing and screw on the clamp knob (H) –do not tighten.

4.Screw the side handle (C) into the clamp knob (H) and tighten.

5.Rotate the side handle mounting assembly to the desired position. For hammerdrilling horizontally with a heavy drill bit, place the side handle assembly at an angle of approximately 20° to the tool for optimum control.

6.Lock the side handle mounting assembly in place by tightening the clamp knob (H).

TO MOUNT IN REAR POSITION (FIG. 3)

1.Unscrew the side handle (C) and remove it from the side handle mounting assembly. Leave the side handle mounting assembly in the front position.

2.Screw the side handle directly into one of the rear side handle positions (I) on either side of the tool.

Active Vibration Control (Fig. 1)

D25602, D25831, D25851

For best vibration control, hold the tool with one hand on the main handle (D) and the other hand on the side handle (C). Apply just enough pressure so the damping device on the main handle is approximately midstroke. The hammer only needs enough pressure to engage the active vibraton control. Applying too much pressure will not make the tool drill or chip faster and active vibration control will not engage.

Inserting and Removing Spline Drive Accessories (Fig. 4)

D25851

WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories.

1.Insert the bit shank into the tool holder (M) as far as it will go. The groove on the chisel shank (Q) must be aligned with the symbol

(R) on the toolholder. If inserted correctly, the locking sleeve (P) moves back to the end position and shows a closed lock symbol.

2.Pull on the bit to be sure that it is properly locked.

32

Page 34
Image 34
DeWalt D25851K instruction manual Active Vibration Control Fig, Inserting and Removing Spline Drive Accessories Fig