HOT SURFACES
PUMP
HEAD 
PUMP CYLINDER
PUMP
HEAD
AFTERCOOLER
you will receive years of
Inspection of Compressor
Inspect for signs of obvious or concealed freight damage. Report any damage to the delivering freight carrier immediately. Be sure that all damaged parts are replaced and any mechanical problems are corrected prior to the operation of the air compressor. The air compressor serial number is located on the shroud of the compressor. Please write the serial number in the space provided in the service section for future reference.
WARNING: When using electric tools, basic safety precautions should always be followed to reduce risk of fire, electric shock, and
English
will remain hot for several minutes after operation. Do not move the compressor while it is running. Hot motor parts could cause burns contributing to the dropping of the compressor, damaging the compressor and/or injuring the operator.
RISK FROM NOISE
CAUTION: Wear appropriate personal hearing 
protection during use. Under some conditions and 
duration of use, noise from this product may contribute to 
hearing loss.
Introduction
Congratulations on the purchase of your new DEWALT Air Compressor! You can be assured that this tool has been constructed with the highest level of precision and accuracy. Each component has been rigorously tested by technicians to ensure the quality, endurance and performance of this air compressor.
By reading the following simple safety, installation, operation, maintenance and troubleshooting steps described in this manual,
personal injury.
DEWALT Air Compressor Features
PRESSURE SWITCH
This switch (A) is used to start or stop the air compressor. Moving the switch to the ON position will provide automatic power to the pressure switch which will allow the motor to start when the air tank pressure is below the factory set
out pressure limit. For ease of starting, this | B | A |
switch also has a pressure release valve |
|
|
located on the side of the switch designed to |
|
|
automatically release compressed air from the |
|
|
air compressor pump head and its discharge |
|
|
line when the air compressor reaches the cut- |
|
|
out pressure limit or is shut off. Moving the |
|
|
switch to the OFF position will open the |
|
|
pressure switch contacts and stop the air |
|
|
compressor. |
|
|
5
