DW7050
DW7052
English
STUD
LOCKNUTS (some models)
STOP
WASHER AND SCREW
CLAMPING BRACKET
END PLATE
(some models)
DW7051
DW7054
JUST FEN | CE |
E | |
ALWAYS ADBEFORE US |
|
PROPERLY |
|
TOP HOLE |
|
|
|
(USE IF ON |
|
|
|
LEFT SIDE) |
|
|
|
KNOBS |
| FENCE | |
ADJUST | USE | ||
ALWAYS | BEFORE |
| |
| PROPERLY |
|
|
| BOTTOM |
|
|
| HOLE |
|
|
| (USE IF ON |
|
|
| RIGHT SIDE) |
|
|
| BRACKET |
|
|
Accessories
Recommended accessories for use with your tool are available at extra cost from your local service center.
CAUTION: The use of any
If you need assistance in locating any accessory, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 or call
Bench Mounting
Holes are provided in all four feet to facilitate bench mount- ing, as shown in Figure 2. (Two different sized holes are provided to accommodate different sizes of screws. Use either hole, it is not necessary to use both.) Always mount your saw firmly to prevent movement. To enhance the tool’s portability, it can be mounted to a piece of 1/2" or thicker plywood which can then be clamped to your work support or moved to other job sites and reclamped.
NOTE: If you elect to mount your saw to a piece of ply- wood, make sure that the mounting screws don’t protrude from the bottom of the wood. The plywood must sit flush on the work support. When clamping the saw to any work sur- face, clamp only on the clamping bosses where the mount- ing screw holes are located. Clamping at any other point will surely interfere with the proper operation of the saw.
CAUTION: To prevent binding and inaccuracy, be sure the mounting surface is not warped or otherwise uneven. If the saw rocks on the surface place a thin piece of mate- rial under one saw foot until the saw sits firmly on the mounting surface.
IMPORTANT SAFETY
INSTRUCTIONS
Changing or Installing a New Saw Blade (Fig. 5, 6)
CAUTION:
•Never depress the spindle lock button while the blade is under power or coasting.
•Do not cut ferrous metal (containing iron or steel) or masonry or fiber cement product with this miter saw.
Removing the Blade
1.Unplug the saw.
2.Raise the arm to the upper position and raise the lower guard (A) as far as possible.
3.Loosen, but do not remove guard bracket screw (B) until the bracket can be raised far enough to access the blade screw.
4
