English
FIG. 1
DW7051
KNOBS
DW7084
DW7082
TOP HOLE (USE FOR DW716)
BRACKET
DW7080
END
PLATE
LOCKNUTS
Clamp: DW7082
Used for firmly clamping workpiece to the saw table for precision cutting.
Dust Bag: DW7053 (Included with some models)
Equipped with a zipper for easy emptying, the dust bag will capture the majority of the sawdust produced (not shown).
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Kerf Plate Blank: DW7055 (not shown)
Used to limit back side tear out of material or as a replacement kerf plate.
Miter Saw Stands: DWX723, DWX724, DWX725B (not shown)
Provides stable and accurate work platform for miter saws.
SAW BLADES: ALWAYS USE 12" (305 mm) SAW BLADES WITH 1" (25.4 mm) ARBOR HOLES. SPEED RATING MUST BE AT LEAST 4800 RPM. Never use a smaller diameter blade. It will not be guarded properly. Use crosscut blades only! Do not use blades designed for ripping, combination blades or blades with hook angles in excess of 7 degrees..
BLADE DESCRIPTIONS
APPLICATION | DIAMETER | TEETH |
Construction Saw Blades (thin kerf with | ||
General Purpose | 12" (305 mm) | 40 |
Fine Crosscuts | 12" (305 mm) | 60 |
Woodworking Saw Blades (provide | smooth, clean cuts) | |
Fine crosscuts | 12" (305 mm) | 80 |
12" (305 mm) | 96 | |
NOTE: For cutting
TCG teeth designed for this purpose.
IMPORTANT SAFETY INSTRUCTIONS
Unpacking Your Saw
Check the contents of your miter saw carton to make sure that you have received all parts. In addition to this instruction manual, the carton should contain:
1.One No. DW716 or DW716XPS miter saw.
2.One DEWALT 12" (305 mm) dia. saw blade
3.One blade wrench in wrench pocket shown in Figure 2.
4.One DW7053 dustbag (some models).
Specifications
Optional Accessories (Fig. 1)
The following accessories, designed for your saw, may be helpful. In some cases, other locally obtained work supports, length stops, clamps, etc., may be more appropriate. Use care in selecting and using accessories.
Extension, Work Support: DW7080
Used to support long overhanging workpieces, the work support is user assembled. Your saw table is designed to accept two work supports; one on each side.
Adjustable Length Stop: DW7051
Requires the use of one work support. It is used to make repetitive cuts of the same length from 0 to 42"
CAPACITY OF CUT 50º miter left and right 48º bevel left and right 0º miter
Max. Height 3.6" (91.5 mm) Max. Width 7.9:" (200.7 mm)
45º miter
Max. Height 3.6" (91.5 mm) Max. Width 5.5” (140 mm)
45º bevel - Left
Max. Height 2.3" (58.4 mm) Max. Width 7.9" (200.7 mm)
Result Width 7.2" (183 mm) Result Height 2.9" (73.7 mm)
Result Width 4.9" (125 mm) Result Height 2.9" (73.7 mm)
Result Width 7.4" (188 mm) Result Height 1.9" (48.3 mm)
4
