DeWalt DW716XPS instruction manual Familiarization, Drive, Volt Motor

45º bevel - Right
Max. Width 7.9" (200.7 mm)	Result Height 1.1" (28 mm)
Max. Height 1.6" (40.6 mm)	Result Width 7.1" (180.3 mm)

Your saw is capable of cutting baseboard moldings 0.9" (22.9 mm) thick by 6" (152 mm) tall on a 45º right or left miter.

NOTE: Your saw is capable of cutting the following once a special set-up procedure is followed (see Special Cuts).

0º miter	height 1.5" (38.1 mm)
	width 10" (255 mm)
45º miter	height 1.5" (38.1 mm)
	width 7.5" (190.5 mm)

DRIVE
120 Volt Motor
1675 Watts (max in)	15 Amp Motor
3800 RPM	Cut Helical Gears
Multi-V Belt	Roller Bearings
Automatic Electric Brake	Carbide Blade

Familiarization
Your miter saw is fully assembled in the carton. Open	FIG. 1A
the box and lift the saw out by the convenient carrying
handle, as shown in Figure 1A. Place the saw on a
smooth, flat surface such as a workbench, strong
table or DEWALT miter saw stand. Examine Figure 2
to become familiar with the saw and its various parts.
The section on adjustments will refer to these terms
and you must know what and where the parts are.

CAUTION: Pinch Hazard. To reduce the risk of injury, keep thumb underneath the handle when pulling the handle down. The lower guard will move up as the handle is pulled down which could cause pinching. The handle is placed close to the guard for special cuts.

English

FIG. 2		OPERATING
		HANDLE			TRIGGER	OPERATING
			DW716
						HANDLE
					SWITCH
		GUARD			CARRY HANDLE
					MOTOR END CAP
LOCK DOWN
PIN					MOTOR
					HOUSING
0º BEVEL STOP							XPSTM ON/OFF SWITCH
ADJUSTMENT		BEVEL SCALE						(DW716XPS ONLY)
SCREW
			RIGHT SIDE					LEFT SIDE
			FENCE			LOCK DOWN		FENCE
					FENCE LOCK
						PIN
			KERF		KNOB
			PLATE		DUST			FENCE LOCK
								KNOB
					SPOUT
				BEVEL LOCK
					KNOB
					0º BEVEL			HAND
								INDENTATIONS
				OVERRIDE KNOB
					45º BEVEL	45º
BENCH MOUNTING	MITER SCALE	MITER				BEVEL STOP
					OVERRIDE
						ADJUSTMENT	BEVEL STOP	BLADE
HOLES		LOCK LEVER			LEVERS
						SCREW	33.9º PAWLS	WRENCH
				5