English
Specifications
Input .......................120 V AC 
, 15 Amp
No load speed........10,000 RPM
Feed speed ............ 14 ft. per minute or 26 ft. per minute
Planing height .........Maximum 6", Minimum 1/8"
Planing width ..........Maximum 13"
Planing depth .........Maximum 1/8" (for boards 6" wide or less)
Electrical Connection
Be sure your power supply agrees with the nameplate marking. Volts, 50/60 Hz or “AC only” means your planer must be operated only with alternating current and never with direct current. Voltage decrease of more than 10% will cause loss of power and overheating. All DEWALT tools are factory tested, if this tool does not operate, check the power
supply. | A |
|
Transporting the Planer | C | |
WARNING: For your own safety, it is | ||
| ||
recommended that two people carry this |
| |
machine or serious injury could result. |
| |
When moving your planer, carry it either |
| |
by the side carrying handles (A) or by the |
| |
handles at the base of the planer (B). When |
| |
transporting or storing the planer, use the |
| |
cord wrap located in the back of the tool (C) | B | |
to keep the cord in place. | D |
Bench Mounting
To facilitate bench mounting, two different sized holes (D) are provided on the four corners of your planer. If mounting the planer with bolts, use the larger holes. If mounting the planer with nails or screws, use the smaller holes. It is not necessary to use both sets of holes.
Always mount your planer firmly to prevent movement. To enhance the tool’s portability, it can be mounted to a piece of 1/2" (12.7mm) or thicker plywood which can then be clamped to your work support or moved to other job sites and reclamped.
NOTE: If you elect to mount your planer onto a piece of plywood, make sure that the mounting screws don’t protrude from the bottom of the wood. The plywood must sit flush on the work support.
CAUTION: The mounting surface should not be warped or otherwise uneven.
ASSEMBLY
WARNING: DO NOT REMOVE GUARDS | E |
| |
(E). Serious injury could result. |
|
WARNING: To reduce the risk of serious |
|
personal injury, turn tool off and |
|
disconnect tool from power source before |
|
making any adjustments or removing/ | G | |||
A | ||||
installing attachments or accessories. |
| |||
| C | |||
TO ATTACH THE DEPTH ADJUSTMENT | ||||
| ||||
CRANK HANDLE |
|
| ||
1. | Remove the screw located in the crank | F | ||
| handle shaft. |
| ||
2. | Insert the crank handle (F) over the shaft. |
| ||
3. | Secure in place with the screw | and |
| |
|
| B | ||
DUST EJECTION PORTS |
| D | ||
|
| |||
Your planer comes with a dust ejection port. The round port (I) as shown below is for use with a 4" dust collector hose.
TO SET UP DUST EJECTION
1.Select the port (I).
2.Depress the lock button (K) on the chip ejection chute (H).
4
