ENGLISH
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the rating plate.
Your DEWALT tool is double insulated in accordance with EN 60745; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially prepared cord available through the DEWALT service organisation.
Mains Plug Replacement (Middle East and Africa)
If a new mains plug needs to be fitted:
•Safely dispose of the old plug.
•Connect the brown lead to the live terminal in the plug.
•Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved extension cable suitable for the power input of this tool (see Technical Data). The minimum conductor size is 1 mm2; the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and disconnect machine from power source before installing and removing accessories, before adjusting or changing set- ups or when making repairs. Be sure the trigger switch is in the OFF position. An accidental
Bench Mounting
1.Mark the position of the four mounting holes provided in the base of the machine on the workbench.
2.Drill appropriate sized hole at each of the marked positions.
3.Place the machine on the workbench and insert a 6 mm hex head bolt with washer through
each mounting hole in the base and into each of the holes drilled in the workbench.
4.Place a nut on each of the bolts and securely tighten the nuts.
Mounting of Spark Guard (fig. 2)
The spark guard offers additional protection from sparks and must be used whenever possible.
NOTE: Spark guards are not designed to replace safety glasses.
1.Loosen screw (d) (do not remove it).
2.Slide spark guard (a) onto bracket.
3.Position the spark guard at a distance of approx. 2 mm from the grinding wheel. Tighten screw (d).
NOTE: Regularly check the distance between spark guard and the grinding wheel and adjust, if necessary. Replace the grinding wheel if spark guard (a) can no longer be adjusted to the maximum distance of 2 mm.
Installing Tool Rest (fig. 3)
WARNING: Use the washers and screws supplied. Longer screws may interfere with the movement of the grinding wheel.
1.Use the supplied bolts, washers, spacers and lock nuts to secure the tool rests (c) in place.
2.Position the tool rest at a distance of approximately 2 mm from the grinding wheel. Regularly check the distance between tool rest (c) and the grinding wheel and adjust, if necessary.
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of injury, turn unit off and disconnect machine from power source before installing and removing accessories, before adjusting or changing set- ups or when making repairs. Be sure the trigger switch is in the OFF position. An accidental
WARNING: Never use a bench grinder if it is not firmly fastened to a work bench or rigid frame. Before turning the grinder on, put on safety glasses.
6
