Keyboard Stand Assembly (DGX-505 Only)

2

e 6 x 30 mm round head screws

xAttach the back board.

Attach the back board, using the 6 x 30 mm round head screws e.

There is no particular vertical or left-to-right orientation for the back board, and it can be installed either way.

CAUTION

Be careful not to drop the back board or touch the sharp metal fit- tings.

3

4

r 5 x 16 mm round head screws

cPut the keyboard on the stand.

Carefully place the keyboard on the side boards. There is no back-to-front orientation for the stand, and

the keyboard can be placed on it facing either direction. Slowly move the keyboard so that the holes on the bottom of the keyboard are properly aligned with the holes on the angle brackets.

CAUTION

Be careful not to drop the keyboard or to get your fingers caught between the keyboard and the stand parts.

vInstall the keyboard to the stand.

Fix the keyboard to the angle brackets, using the 5 x 16 mm round head screws r.

Post-assembly checklist

Once you’ve assembled the stand, check the following points:

Are there any parts left over?

If so, read the assembly instructions again and correct any errors you might have made.

Is the instrument clear of doors and other movable fixtures?

If not, move the instrument to an appropriate location.

Does the instrument make a rattling noise when you play it or move it?

If so, properly tighten all screws.

Also, if the keyboard makes a creaking noise or seems unsteady when you play it, refer carefully to the assembly instructions and diagrams and retighten all screws.

94 DGX-505/305 Owner’s Manual

Page 94
Image 94
Yamaha DGX-305 manual Keyboard Stand Assembly DGX-505 Only, Attach the back board, Put the keyboard on the stand