DeWalt DWFP55130 Regulator is not adjusted correctly, Tank pressure exceeds pressure, Gauge

English

CODE	POSSIBLE CAUSE	POSSIBLE SOLUTION
7	Regulator is not adjusted correctly	It is normal for some pressure drop to occur when an accessory is used, adjust the regulator
	for accessory being used	as instructed in Regulator under Features if pressure drop is excessive.
		NOTE: Adjust the regulated pressure under flow conditions while accessory is being used.
8	Prolonged excessive use of air	Decrease amount of air usage.
9	Compressor is not large enough for	Check the accessory air requirement. If it is higher than the CFM or pressure supplied by your
	accessory	air compressor, a larger compressor is needed to operate accessory.
10	Hole in air hose	Replace air hose.
11	Check valve restricted	Contact a DEWALT factory service center or a DEWALT authorized service center.
12	Air leaks	Tighten fittings.
13	Regulator is damaged	Replace.
14	Motor overload protection switch	Refer to Motor Overload Protection under Features. If motor overload protection trips
	has tripped	frequently, contact a DEWALT factory service center or a DEWALT authorized service center.
15	Tank pressure exceeds pressure	Motor will start automatically when tank pressure drops below cut-in pressure of pressure
	switch cut-in pressure	switch.
16	Extension cord is wrong length or	Check for proper gauge wire and cord length. Refer to the Extension Cords paragraph in
	gauge	the Installation section.
17	Loose electrical connections	Contact a DEWALT factory service center or a DEWALT authorized service center.
18	Possible defective motor	Contact a DEWALT factory service center or a DEWALT authorized service center.
19	Paint spray on internal motor parts	Contact a DEWALT factory service center or a DEWALT authorized service center. Do not
		operate the compressor in the paint spray area. See flammable vapor warning.
20	Fuse blown, circuit breaker tripped	1. Check fuse box for blown fuse and replace as necessary. Reset circuit breaker. Do not
		use a fuse or circuit breaker with higher rating than that specified for our particular branch
		circuit.
		2. Check for proper fuse. You should use a time delay fuse.
		3. Check for low voltage conditions and/or proper extension cord.
		4. Disconnect the other electrical appliances from circuit or operate the compressor on its
		own branch circuit.
		16