English
Using A Palm Sander Continued
9) When using the tool, always adopt a firm footing and/or position | |
| and grip the tool firmly to counteract any forces or reaction |
| forces that may be generated while using the tool. |
10) Use only genuine Dewalt spare parts or parts which perform | |
| equivalently. Do not make temporary or permanent repairs with |
| unauthorized parts. |
11) | Do not lock, tape, wire, etc., the on/off trigger in the run |
| position. The trigger must always be free to return to |
| the “off” position when it is released. |
12) | Always shut off the air supply to the tool and depress the |
| trigger to release air from the feed hose before fitting, |
| adjusting or removing the working attachment. |
13) | Check hoses and fittings regularly for wear. Replace if |
| necessary. Do not carry the tool by its hose. Ensure the |
| hand is removed from the on/off trigger when carrying |
| the tool with the air supply connected. |
14) Take care against entanglement of moving tool parts | |
| with clothing, ties, hair, cleaning rags, etc. This will |
| cause the body to be drawn towards the tool and can |
| be very dangerous. |
15) | Safe working practices and observe all relevant legal |
| requirements when installing, using or maintaining the tool. |
16) | Only install the tool when an easily accessible and easily |
| operable on/off switch is incorporated in the air supply. |
17) Take care that the tool exhaust air does not | |
| cause problems or blow onto another person. |
18) | Never lay a tool down unless the working attachment has |
| stopped moving. |
19) | Always begin sanding with sandpaper coarse enough to |
| remove high spots on the surface to be sanded. |
PRE-START CHECKLIST
•Drain water from air compressor tank and condensation from air lines. (Please refer to air compressor’s operation manual.)
•Lubricate the tool.(Please refer to the “Maintenance” section
in the manual.)
WARNING: Risk of unsafe operation. Firmly grasp air hose with hand when installing or disconnenting to prevent hose whip.
WARNING: Risk of bursting. Too much air pressure causes a hazardous risk of bursting. Check the manufacture’s maximum pressure rating for air tools and accessories. The regulator output pressure must never exceed the maximun pressure rating.
NOTE: The use of a quick connect set makes connecting easier
IMPORTANT:The use of air filters and air line lubricators is recommended.
SANDER PAD ASSEMBLY
•Disconnect the tool from the air supply before assembling or disassembling the sander pad.
•To disassemble the sanding pad (B), slide the supplied wrench between the sander pad (B) and skirt (G) until the wrench is in contact with the flats of the balance shaft nut (H).
•Hold the wrench firmly and rotate the sander pad (B) counterclockwise to loosen it from the tool.
WRENCH
G
WRENCH
Progress to finer grit sandpaper until the desired finish is |
obtained. |
20) Always use sandpaper appropriate for the surface |
being sanded. |
B
H
12
