DeWalt DPD3000IC, N0003431 Troubleshooting Codes, Code Possible cause, Possible Solution

(Troubleshooting Codes cont.)

		Troubleshooting Codes
Code	possible cause	POSSIBLE SOLUTION
1	No fuel.	Add fuel.
2	Low oil.	Add required amount of oil.

3Pressure builds up after two pulls on the recoil starter or after initial Squeeze gun trigger to relieve pressure­. use.

4	Choke lever in the No Choke position.	Move choke to the Choke posi­tion­.
5	Spark plug wire not attached.	Attach spark plug wire.
6	Engine ON/OFF switch in OFF posi­tion­.	Place engine ON/OFF switch in on position.
7	Choke lever in the Choke position on a hot engine or an engine	Move choke to the No Choke posi­tion­.
	that has been exposed to thermal heat for a long period of time.
8	Fuel valve closed.	Move the fuel valve lever to the Open position.
9	Spray wand not in high pressure.	See Spray Wand Nozzles under Operation.
10	Low water supply.	Water supply must be at least 5 GPM @ 20 pSI (138 kPa).
11	Leak at high-pressure hose fitting.	Repair leak. Apply sealant tape if necessary.
12	Nozzle obstructed.	See Nozzle Cleaning under Maintenance.
13	Water filter screen clogged.	Remove and clean filter.
14	Air in hose.	Turn off the engine, then the water source. Disconnect the
		water source from the pump inlet and turn the water source
		on to remove all air from the hose. When there is a steady
		stream of water present, turn water source off. Reconnect­
		water source to pump inlet and turn on water­ source. Squeeze
		trigger to remove­ remain­ing­ air.
15	Choke lever in the Choke position.	Move choke to the No Choke posi­tion­.
16	High-pressure hose is too long.	Use high-pressure hose under 100 feet (30.48 m). Lengthen water
		supply hose instead of high-pressure hose.

English

19