4. PBX Systems
4.5.1. Nortel Norstar Programming Requirements
There are specific switch programming requirements that apply if using a
Dialogic® PBX Integration Board with a Nortel Norstar. Pay attention to set
these features exactly (and assigned to the right keys) so that the PBX
Integration Board and the associated APIs can function correctly.
Nortel Norstar Programming Requirements for DR5
Table 23 lists the menu structure used if configuring a Nortel Norstar (with
DR5 or later revision installed). The shaded areas indicate the actual menu
items to change if using the KSU with a Dialogic® PBX Integration Board.
For details about programming a Norstar KSU, refer to the appropriate Norstar
manual.
The table only shows the configuration for one trunk line (001) and one
extension (221). If you are using more than one trunk line, configure each
trunk line the same. If you are using more than one extension, check that all
the extensions are configured the same with the exception of the Forward on
busy and Forward no answer options. For these menu items, the first
extension should be forwarded to the second extension and the second
extension should be forwarded to the third extension, and so on. The last
extension should be forwarded back to the first extension.
Table 23. Norstar Configuration Requirements (DR5)
Menu Option/Default Value New Value
A-Configuration
1. Trk/Line Data
a) Show line: Enter Trunk # 001
b) Trunk data
Line001: Loop*
Trunk mode: Supr
Dial mode: Pulse Tone
Full AutoHold: N
c) Line data
105