Speakers On Front

Mixed-Mode System On Rear Full-Range

SOURCE

2CH BASS 2CH 4CH

D3 400.4

LOW HIGH FULL

NOTE Chart values based on 4 ohm speakers.

Fig.13 The amplifier can be configured for a mixed-mode operation on either channels 1/2 or 3/4 amplifier sections. The table provides component values to create a 6dB per octave crossover at specified frequencies. Use the same frequency for both LP and HP crossovers. Do not overlap frequencies, as this may damage the amplifier.

Page 13

Image 13

Diamond Audio Technology D3 Series specifications Mixed-ModeSystem On Rear Full-Range, Speakers On Front

Contents

INTRODUCTION TABLE OF CONTENTSDESCRIPTION POWER AND SPEAKER CONNECTIONS SPECIFICATIONS Fig.3 D3 INPUT CONNECTIONS AND AUDIO CONTROL SETTING THE CROSSOVER SETTING THE GAINSETTING THE BASS BOOST TROUBLESHOOTING Bridged-MonoSubwoofer System SYSTEM DIAGRAMS Specifications Set X-OverMode to FULL ADJUST FREQ to speakerSet X-OverMode to LOW ADJUST FREQ to speaker Specifications Mixed-ModeSatellite and Subwoofer System NOTE Chart values based on 4 ohm speakersSet X-OverMode to FULL Fig.8 Electrical connections for the D3 SOURCE 2CH BASS 2CH 4CH full-rangespeakers in stereoLOW HIGH FULL LOW HIGH FULL 2-Channel High-Pass. 2-Channel Low-Pass 4-ChannelStereo SystemSOURCE 2CH BASS 2CH 4CH Bridged Mono Channel 2-ChannelStereo System with Low-passSOURCE 2CH BASS 2CH 4CH LOW HIGH FULL LOW HIGH FULL SOURCE 2CH BASS 2CH 4CHLOW HIGH FULL SOURCE 2CH BASS 2CH 4CH Mixed-ModeSystem On Rear Full-Range NOTE Chart values based on 4 ohm speakersSpeakers On Front Fig.14 Electrcal connections for the D3 Listen as the Artist Intended D I A M O N DHead Office 410 5. Benson Lane Chandler, AZ Tel LIMITED WARRANTY STATEMENT w ww . di amo nd au di o .c om A U D I O T E C H N O L O G YSerial Number Date of Purchase

Diamond Audio Technology D3 Series Mixed-ModeSystem On Rear Full-Range, Speakers On Front

Models: D3 Series

Mixed-Mode System On Rear Full-Range

Speakers On Front

NOTE Chart values based on 4 ohm speakers.