“Mounting…”
Split Crossover
Cover
Crossover
Speed | Grille Ring |
Clips |
Gasket
Midbass/
Woofer
Screws
Spring
Clip
Mounting | Grille |
| |
Cup |
|
| Tweeter |
Check your available mounting depth before installing your HEX™ components. Use extreme care when removing factory speakers, grilles and/or door panels. Be sure to install the supplied foam gaskets on the drivers to insure a good “seal” for maximum dynamic range.
Turn Clockwise | Turn Counterclockwise |
to tighten setscrew. | to loosen setscrew. |
The terminals on the HEX drivers feature a new recessed mechanism to allow direct connection of the speaker cable up to 12 guage (2.5mm²). Simply strip the end of the cable to 5/16” (8mm) DO NOT SOLDER, insert into terminal and tighten down using a #0/1
Speaker cable strip guage. Strip end of wire to match illustration.
8mm
*Up to 12AWG (2x2.5mm²) speaker wire.
