Digi M10 manual Digi Extended Packets, Temperature Out of Bounds Packet

Digi m10 Technical Overview

4. Digi Extended Packets

In addition to the ORBCOMM serial commands defined in the ORBCOMM Serial Specification, the following Digi Extended Packets are available to the host controller:

•Temperature Out of Bounds Packet

•Temperature Query

•Temperature Query Response

•NVM Data Corruption Alert Packet

•Code Upgrade Packet

•RTS/CTS Control Packet

The following sections provide details about these packets.

4.1Temperature Out of Bounds Packet

Table 2: Temperature Out of Bounds Packet

0	0x05/0x06	Packet Header
1	0x18	Packet Type
2	Length0
		Length of the packet
3	Length1
4	Retry_count/ Pkt Sequence Number
5	Temp0
6	Temp1	Temperature value
		in little endian
7	Temp2	format.(This is a 32
		bit floating point
8	Temp3	number)
9	Fletch0
		Fletcher Checksum
10	Fletch1

NOTE: This packet is sent from the Digi m10 to DTE when temperature of the Digi m10 goes beyond the operating range (-40C to +85 C). DTE should power down the Digi m10 when this packet is received.

Digi International, Inc. © 2009 Page 18 of 26