Digi NS9210 LEDs

44 NS9210 Processor Module Hardware Reference

Chapter 2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

LEDs

WLAN LED LE7 Reserved for future use.

Power LEDs, LE3

and LE4 The power LEDs are all red LEDs. These power supplies must be present and cannot

be switched.

LE3 ON indicates the +9VDC / +30VDC power is present.

LE4 ON indicates the +3.3VDC power is present.

User LEDs, LE5

and LE6 The user LEDs are controlled through applications running on the NS9210 Processor

Module, if J5 and J4 are set. Use these module signals to implement the LEDs:

Power LED +3.3V, LE4Power LED 9-30V, LE3 WLAN LED LE7

Serial Port D

status LEDs

Serial Port B

status (MEI)

LEDs

User LED2,

LE6

User LED1,

LE5

Contents

Main Page Contents . . . . . . . Page Page Page Digi information Page About the Module T Features and functionality Module pinout Pinout legend: Type X1 pinout Page Page Page X2 pinout Page Page Page Page Page Page Page Configuration pins CPU Configuration pins Module Clock generation Boot process Chip selects SDRAM banks Multiplexed GPIO pins Page Page Page Page Page Interfaces Power About the Development Board T Page Page User interface Switches and pushbuttons Page Serial Port B MEI configuration switches, S1 Use S1 to configure the line interface for serial port B MEI: Jumpers Jumper functions Battery and Battery Holder LEDs Page Serial UART ports Page Page Page I2C interface The I/O expander is a Philips PCA9554D at I2C address 0x20 / 0x21. The pins are allocated as shown: SPI interface Pin allocation SPI connector pins are allocated as shown: Current Measurement Option JTAG interface PoE module connectors - IEEE802.3af Page Ethernet interface RJ-45 pin allocation, X19 RJ-45 connector pins are configured as shown: Peripheral (expansion) headers Page Module and test connectors X10 pinout *USB signals are reserved for future use. X11 pinout *USB signals are reserved for future use. X20 pinout X21 pinout Page Appendix A:Specifications T Environmental specifications Mechanical specifications Safety statements A Power requirements Typical module current / power measurements Typical power save module / JumpStart board current / power consumption measurements Page Layout recommendation BOTTOM View TOP View SIDE View Page Reset and edge sensitive input timing requirements t Page Appendix B:Certifications T FCC Part 15 Class B Radio Frequency Interface (RFI) (FCC 15.105) Labeling Requirements (FCC 15.19) B Modifications (FCC 15.21) Industry Canada Declaration of Conformity B International EMC Standards The NS9210 Processor Module meets the following standards: