Digi W R 4 4 V 2 manual TransPort WR44v2 Installation Guide

TransPort® WR44v2 Installation Guide

1.ASY Serial Port (3x) - Provides three additional asynchronous RS232 serial ports using RJ45 connectors.

2.SYN/ASYN Serial Port - Provides an X.21/RS422/RS232 synchronous / asynchronous serial port using a DB25 connector.

3.GPS - Provides GPS capabilities using an SMA male connector.

4.ISDN - Provides an ISDN Basic Rate Interface (BRI) via an RJ45 port. This can be configured either as a TE (terminal endpoint) or as NT-1 (network termination). The option also includes an additional asynchronous serial port via a second RJ45 port.

5.Telemetry 1 I/O Interface - Provides 4 opto-isolated digital input ports and 1 opto-isolated digital output port. It also provides a relay I/O port, a voltage monitoring port, and internal temperature monitoring.

6.Telemetry 2 I/O Interface - Provides 4 isolated analog I/O ports and 4 non-isolated digital I/O ports.

7.Fleet I/O Interface - Provides CAN and J1708 interface, GPS, 4 non-isolated digital I/O ports, ignition sense port, and a 3 axis accelerometer.

8.PSTN - Provides a PSTN interface via an RJ45 connector that can be used to dial out and receive calls.

9.ISDN-U/PSTN - Provides an ISDN-U interface suitable for the USA plus PSTN interface. It can be configured for Bell-103 modulation in leased line mode as well as a normal PSTN interface.

10.DialServ - This RJ11/FXS connection converts a PSTN analog modem to a RS-232 serial signal.

For more information on the Telemetry 1, Telemetry 2, and the Fleet I/O Interfaces please see the product specific user’s guides which can be found at: http://ftp1.digi.com/support/documentation/transport/technicalnotes.htm

Page 13