Dimension One Spas D1 Spas Series Chairman Architectural Specification, Top View of Spa, Sis

2004 Chairman Specifications Dimension One Spas

2004 Chairman

Architectural Specification

R16 in [R41 cm]

R16 in [R41 cm]

	16 in [41 cm]		19 in [48
		12 in [31 cm]
	16 in [41 cm]
		Top View of Spa		91 1/2 in [232 cm]
			18 1/2 in [47 cm]
				Shell
				See Caution
				91 in [231 cm]
		THIS 3 FOOT SQUARE AREA,		Skirt
		ON BOTTOM OF SPA, TO BE	SIS
		SUPPORTED CONSISTENT WITH
		THE EDGES OF SPA BASE.
			88 1/2 in [225 cm]
			Pedestal
			Base
26 1/2 in [67 cm]	See Note 5	Equipment Compartment
Recommended location
for
Electrical
Inlet
11 in [28 cm]
Hose Bib/
Water Drain
		Vent	23 1/2 in [60 cm]
Vent	Vent		34 1/2 in [88 cm]

56 1/2 in [143 cm] 67 1/2 in [171 cm]

91 1/2 in [232 cm]

Control

Spa Lip

Front View of Spa

35 1/2 in [90 cm]

32 in [81 cm]

Hose Bib/
Water Drain
	Pedestal Base
3 1/2 in [9 cm]	Door Extends
	Under Spa Lip
	16 in [41 cm]
	75 in [191 cm]
	89 in [225 cm]
	91 in [231 cm]

Note: 1. Subject to change without notice.

2.Engineering specs may differ slightly from brochure.

3.For E-Z lifter installation allow 18” clearances on the backside of the spa.

4.Alternative cabinets may add significant weight. Ask your dealer for exact details

5.This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa. Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).

Caution:

Due to manufacturing tolerances there could be some

minor differences between the actual spa and the drawing above.

If site planning is critical to such tolerances, be sure to measure your actual spa.

Doc-869 Rev - A Rev Date: 11/7/03 Specification, 2004, Chairman Page 2 of 5