Dimension One Spas Home Series owner manual Programming the Spa Functions, Filter Cycle Duration

Dimension One Spas – @Home Series Owner’s Manual

Control Function

8

9

8.TEMPERATURE Buttons

Control the water temperature with the Up (+) and Down (-) Buttons. Push a button once to change the temperature by one degree, or hold it down to rapidly change it by many degrees. The temperature can be set no higher than 104 ° F (40° C).

While setting the temperature, the Set Point light on the Control Panel will glow to indicate that the display is showing the desired Set Temperature and not the actual temperature.

After the desired temperature is set, the Display Window will revert to showing the actual water temperature. The hot tub will heat to the new Set Temperature automatically.

9.PROGRAM Button

Push PROGRAM to begin the process of programming the spa functions. See the section on “Programming the Spa Functions” for details.

To initiate the programming sequence at any time, hold PROGRAM for 3 seconds. If within 10 seconds no button is pushed, the spa will automatically exit the programming sequence and revert to the pre-set factory default settings. To exit the programming sequence at any time, do not press any button for 10 seconds. Any programming changes made up to that point are saved.

Programming the Spa Functions

To initiate the programming sequence at any time, hold PROGRAM for 3 seconds. If within 10 seconds no button is pushed, the spa will automatically exit the programming sequence and revert to the pre-set factory default settings. To exit the programming sequence at any time, do not press any button for 10 seconds. Any programming changes made up to that point are saved.

Filter Cycle Duration

Pressing PROGRAM sets the Filter Cycle Duration. This tells the spa how long to run during each filter cycle. Use the UP or DOWN to choose from 60, 90, 120, 150, or 180 minutes. The factory default is 60 minutes. After setting the desired duration, press the Program button again to move to the next step.

Number of Filter Cycles

After setting the Filter Cycle Duration set the Number of Filter Cycles the spa will run each day. Use UP and DOWN to choose 1, 2, 3, or 4 cycles per day. The factory default is 2 times per day. Then press PROGRAM to move on to the next step.

NOTE: The spa considers the “Start Time” of the first filter cycle to be one minute after its power is turned on. To change the starting time of the first filter cycle and all following cycles, turn the spa power off and then on at the desired time of day to reset it. All other programs will need to be reset because they will revert to factory settings.

10