Dimplex 6903950000 manual Remove glass assembly Figure

5.Adjust the wall-mounting bracket so the bubble on the level is centered between the two black lines.

6.Mark 5 other mounting screw locations, on the wall, ensuring that the wall bracket stays level.

7.Install the supplied wall anchors on the marked locations by placing a #2 phillips screwdriver into the recess of the anchor. Press the anchor into the wall in the desired marked position while turning the anchor clockwise until it is flush with the wall

9.Insert the wall anchor screws through the wall bracket and thread into the wall anchors. Tighten the screw. (FIGURE 4)

10.Install the remaining screws through the bracket and into the wall studs as required.

Note: At least two of the mounting screws must be installed into a wall stud.

Wall Anchor

Screw

Wall Bracket

Figure 4

11. Remove glass assembly (Figure 5).

6