FIREPLACE INSTALLATION
1.Make sure the units MAIN ON/OFF switch is switched OFF (refer to operating instruction section).
2.Plug the unit into a 15Amp/120VAC outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1875 watts.
36920.25
14375.75
33.75
857
OPERATION - see Fig. 2
Three switches provide a choice of heat settings. A switch is in the ON position when the side with the markings on
(i.e. I, I, or II) is pushed in.
Switch 1 (I) Controls the electricity supply to the heater and flame effect.
Note: This switch must be in the ON
(I)position for heater to operate with or without heat.
Switch 2 (I) Provides 715 W heat output. Switch 3 (II) Provides 1430 W heat output with
switch 2.
3 | 2 | 1 |
II | I | FIG. 2 |
|
|
6