Operation
To access the controls, swing down the front cover panel located on the lower front of the fireplace (refer to diagram below). (Figure 8)
A. Main ON/OFF Switch
The switch has two ON positions
marked with 
and “Manual”. The “Manual“ position is for manual operation. In this position the
The 
position is for operating the unit with the provided remote control.
When in 
position the unit is operated with the ON and OFF buttons of the remote control.
When the switch is in the center position the unit is off.
B. 
Heater ON/OFF Switch
The Heater ON/OFF Switch supplies power to the heater fan and the heater element.
When the switch is in the ON
position the heater operates if the thermostat calls for heat.
C. 
Heater Thermostat Control
To adjust the temperature to your individual requirements, turn the thermostat control clockwise all the way to turn on the heater. When the room reaches the desired temperature, turn the thermostat knob counter clockwise until you hear a click. Leave in this position to maintain the room temperature at this setting. For additional heat, turn clockwise until you hear the click again and the heater will turn on.
Resetting The
Temperature Cutoff
Switch
Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It can be reset by switching the Main ON/OFF Switch to OFF and waiting 5 minutes before switching the unit back on.
Figure 8 |
11 |
