Operation
CAUTION: If you need to continuously reset the heater, unplug the unit and call technical support at
!NOTE: The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by initial heating of internal heater parts and will not occur again.
Remote Operation
The fireplace is supplied with an integrated On/Off remote control.
!Note: Ensure that the fireplace 3 position switch is set to the remote control setting. To operate, push the ON button to turn fireplace on, push the OFF button to turn the fireplace off.
and then place the Main ON/ OFF Switch in the Remote Control position.
3.Within 10 seconds of changing the switch position, press the ON button located on the remote control transmitter (Figure 9). This will synchronize the remote control transmitter and the fireplace receiver.
!NOTE: You will have only 10 seconds to perform this last step.
Failure to do so will result in these steps needing to be followed again.
Battery Replacement
To replace the battery:
1. Slide battery cover open on
Remote Control Initialization/ | Figure 9 | ||
Reprogram |
| ||
In the event that your remote |
| ||
control ceases to operate your | ON | ||
fireplace, follow these steps | |||
Button | |||
to reinitialize the hand held | |||
OFF | |||
transmitter and the remote control | |||
receiver in the fireplace: | Button | ||
1. Place the Main ON/OFF |
| ||
| Switch (Figure 8A) in the OFF |
| |
| (“o”) position. |
| |
2. | Wait a minimum of 5 seconds | Battery | |
|
| Battery Cover | |
12 |
| www.dimplex.com | |
