Fireplace Installation
!NOTE: Wall anchors must be installed in the appropriate wall locations to fasten the wall bracket through the remaining holes (Figure 3). For example, if you plan to secure the bracket to studs through holes A&F, install anchors centered on holes B, C, D, and E.
Figure 3 | Wall anchor |
Screw | Wall |
| bracket |
③Hold the
④Place the bubble level onto the top of the wall- mounting bracket.
⑤Adjust the
⑥Mark five (5) other mounting screw locations, on the wall, ensuring that the wall bracket stays level.
⑦Install the supplied wall anchors on the marked locations by placing a #2 Phillips screwdriver into the recess of the anchor.
⑧Press the anchor into the wall in the desired marked position while turning the anchor clockwise until it is flush with the wall.
⑨Insert the wall anchor screws through the wall bracket and thread into the wall anchors. Tighten the screw (Figure 3).
⑩Install the remaining screws through the bracket and into the wall studs as required.
!Note: At least two of the mounting screws must be installed into a wall stud.
⑪Remove glass assembly (Figure 4).
⑫Mount the unit on the wall as shown (Figure 5).
⑬Fix the unit in place by inserting two (2) screws through 2 of the 4 available back panel holes, and into the wall studs. If studs are unattainable please use wall anchors (Figure 6).
⑭With the glass assembly out remove the 4 screws holding the top frame piece in place - 2 on each end. (Figure 7)
Figure 4
2
3
1
Figure 5
Wall Bracket
Supports
Wall Bracket
Figure 6
Panel Mounting Holes
6 | www.dimplex.com |