Dimplex V1525BT, V1525RT manual

WARNING

Ensure method of installation does not obscure the air intake slots on bottom of unit in any manner. Keep minimum 4" clearance from bottom of unit to any surface such as the top of a cabinet.

3.Wire a dedicated, properly fused circuit with 120V, 15amp rating. Allow up to 8 feet of service cable for connecting power supply to junction box on fireplace when installing after finishing wall.

CAUTION

Use two conductor, non-metallic sheath cable with ground wire (3 wires total) for the incoming power supply on fireplace inserts. Use appropriate wire to meet local and national electrical codes for rated power consumption.

4.Remove the outer jacket and strip the individual conductor from the end.

5.Loosen the screw securing the junction box cover and remove the cover.

6.Take the cables out from the junction box, loosen the two wire twist nuts and remove the cord set. (FIGURE 6.)

Figure 6

10