Wall Control Installation

!NOTE: All electrical wiring must comply with all national and local electrical codes and regulations. Always use a qualified and licensed electrician should you have any questions or concerns for all wiring work.

!NOTE: The Wall Switch Remote Control is made to fit standard Decora style faceplates. Due to material inconsistencies of individual faceplates, it may be necessary to remove the faceplate for operations such as changing batteries.

Site Selection for

Installation

Although this Wall Switch Remote Control can operate on battery power or by hard wire installation, a convenient and accessible location should be chosen. The range of the Wall Switch Remote Control is approximately 50 feet (15 m).

Installation requires the use of a standard device box and should the hard wire installation method be chosen, a location near an

available 24V~ power source should be considered.

WARNING: Electrocution or other bodily harm and property damage can occur if a live wire is touched or damaged during installation. Always consult electrical schematics for the installation location of all wiring or consult a qualified and licensed electrician before you begin.

Installation

Required Tools and Hardware:

Flat head screwdriver

Wire cutters / strippers

Two (2) wire nuts for 22 AWG wire

Standard wall device box with minimum depth of 2.5 inches (6.35 cm)

24V~ Power supply (for hard wired power installation if applicable)

Battery Powered Installation

1.Remove the Wall Switch Remote Control and installation hardware from its package.

7

Page 7
Image 7
Dimplex WRCPF-KIT owner manual Wall Control Installation, Required Tools and Hardware, Battery Powered Installation