Dimplex WRCPF-KIT Initialization, BF Models Using the Included Receiver Module, BLF50 Models

Initialization

After installation, locate the section which applies to your specific model of fireplace and follow the steps for remote control initialization and if required, re-initialization. Refer to your fireplace's owner's manual to locate manual or other controls as needed.

BF Models Using the Included Receiver Module

1.Ensure that power is supplied through main service panel.

2.Inside the fireplace, locate the toggle switch on the manual controls and set to “Remote” (Figure 17-C).

Figure 17		A	B	C
D	E	F

3.Press and hold the On button on the manual controls

(Figure 17-A) for five (5) seconds. The Level 1 Indicator Light (Figure 17-D) will then flash for 10 seconds.

4.Press any button on the Wall Switch Remote Control within that 10 seconds.

BLF50 Models

1.Ensure that power is supplied through main service panel.

2.Inside the fireplace, turn Main On/Off Switch to Off (Figure 18-A) and wait 10 seconds.

3.Move the Three Position Switch (Figure 18-B) to the “ REMOTE ” position.

Figure 18

C B A

BLF50 Manual controls

4.Turn Main On/Off Switch to On.

5.Press and hold the Manual Control Button marked “

I ” (Figure 18-C) for five

(5) seconds. After five (5) seconds, there is a 10 second window to press any button on the remote control.

6.Press any button on the Wall Switch Remote Control within that 10 seconds.

14 www.dimplex.com