19.Output Source HP/LP/FULL Switch: Select the desired crossover setting, HP/LP/FULL for the RCA output signal.
20.Output Crossover Freq. Control: Use this control to adjust the output crossover frequency from 30Hz to4kHz.
21.Output Crossover HP/LP/FULL Switch: Select the desired crossover setting, HP/LP/FULL for the internal output signal of the RCA output.
Note: See the next section for the rear panel view of this endplate.
A1200/4 END PLATE DIAGRAM
12
QBASS
REMOTE
3 | 4 |
+18 | 0 |
QBASS
1.Power/Ground PowerLockTM: After you have securely connected your power and ground wires, plug in the Power/Ground PowerLockTM connector here.
2.QBASS REMOTETM: Plug in the data cable from the optional QBASS REMOTETM dash mounted level control here. (The remote level control will bypass the amplifier’s on board QBASSTM control.
3.QBASS PLUSTM: Up to 18dB of bass level control boost.
4.Cooling Plenums: Maintain a minimum 2” clearance around cooling plenums for proper amplifier cooling.
19
