TOP PANEL CONTROLS

1.Input Gain Adjustment - Controls the amplifier’s sensitivity and is used to match the input level of the amplifier to the output level of the signal source.

2.Crossover Frequency Adjustment - Adjusts the crossover point for the on-board low-pass crossover.

3.Variable Bass EQ - Adds 0 to12db of additional boost to the subwoofer output when active.

4.Sub Phase Adjustment - Controls the phase of the subwoofer output from 0 to 180 degrees.

5.Subsonic Frequency Adjustment - Adjusts the cutoff point for SUBSONIC frequencies. Frequencies below the adjustment point will be attenuated by 24db per octave.

6.Variable Subsonic Filter Switch - Turns the Variable SUBSONIC filter control on/off.

FIGURE 4—AMPLIFIER CONTROLS TOP

 

2

1

3

4

5 6

© 2002 Directed Electronics, Inc

11