FRONT PANEL CONNECTIONS

1.RCA Input Jacks - Accepts line level outputs from head units or signal processors at voltages between 150mV and 8 volts.

2.RCA Sync Out Jack - This RCA jack sends a synced, or in-phase, gain matched signal to a slave d2500.1 when connected in the Parallel Synced Gain combination. (Refer to Combined Amplifiers section of this guide.)

3.RCA Slave In Jack - This RCA accepts input from a master d2500.1 when connected in the Parallel Synced Gain combination. (Refer to Combined Amplifiers section of this guide.)

4.Slave/Master Switch - Controls whether the amplifier is a slave or master when connected in the Parallel Synced Gain combination. (Refer to the Combined Amplifiers section of this guide.)

5.Remote Sub Level Control - Controls the subwoofer amplifier gain controls from a remote location for ease of adjustment during listening.

Warning: DO NOT connect a level control knob from other manufacturers to the Remote Sub Level Control of any Viper amplifier. Even though the connectors fit properly, the control knob and connector pin positions may be different and the amplifier will be damaged.

FIGURE 1—AMPLIFIER CONNECTIONS d2500.1 FRONT

1

2

3

4

5

8

© 2002 Directed Electronics, Inc