CONTROL
MODULE
OVERRIDE SWITCH
GRAY
BLACK
Pro Security Programmer interface, 3-pin port
The BLACK
more information please refer to the guide packaged with the programmer.
module programming
The System Features Learn Routine dictates how the unit operates. It is possible to access and change any of the feature settings using the Override switch. However, this process can be greatly simplified by using the Pro Security Programmer. Any of the settings can be changed and then assigned to a par- ticular transmitter, up to four, a feature called individual recognition. Each time that particular trans- mitter is used to disarm the system, the assigned feature settings will be recalled. Individual recognition is only possible when programming the unit via the Pro Security Programmer.
If the system was previously programmed using the Pro Security Programmer, the learn routine may be locked. If the horn generates one long honk when attempting to program the unit, the learn routine is locked and must be unlocked using the Pro Security Programmer before proceeding.
To enter the learn routine:
1.Key. Turn the ignition on and then back off.
2. Choose. Within 10 seconds, press and release the Override switch the number of 
times corresponding to the feature number you want to program. (See Feature 
Menus.) Once the Override switch has been pressed and released the desired num- ber of times, press it once more and hold it. After a second, the LED will flash and the
horn will honk to indicate which feature you have accessed.
9
