O W N E R ’ S G U I D E
INSTALLATION GUIDE
Wireless FM Transmitter
MODEL WFM100
Wiring Diagram
Channel Select Switch
88.7, 88.5, 88.3, 88.1 MHz
Power ON
LED
Power
Switch
88.7 88.5 88.3 88.1
INTRODUCTION
RCA Cable
Power Input
WFM100
Antenna
Mono/Stereo Switch
The audio input to the WFM100 can be connected to either the
WIRE HARNESS WITH RCA CONNECTORS
1.Use the dual RCA cable and connect one end to the Red and White jacks. Connect the other end to the low level signal source. Ensure that you observe the left and right polarity at both ends of the cable.
2.Connect power and ground wire connector to 12Vdc input wires. Connect the Black
FCC RF EXPOSURE COMPLIANCE
This low power transmitter complies with the following standards and guidelines for limiting RF exposure for the general population/uncontrolled environment. It complies with the following standards and guidelines
FCC
FCC OET Bulletin 65 Edition
ANSI/IEEE C95.1 - 1992 - IEEE standard for safety levels with respect to human exposure to radio frequency electromagnetic fields, 3kHz to 300GHz.
ANSI/IEEE C95.3 - 1992 - IEEE recommended practice for the measurement of potentially hazardous electro- magnetic fields - RF and microwave.
© 2004 Directed Electronics, Inc. | 1 | N86102 09/04 |
|