24
CHECKING THE CODES Ifyou have set up the DIRECTV® Universal Remote
Controlusing the Searching For Your Codeprocedure (on
the previous page),you may need to find out which four-
digit code is operating your equipment.For example,to
find out which code is operating your TV:
1. Turn on your TV.
2. On the DIRECTV Universal Remote Control,
press TV once.Then press and hold Setup until
the TVkey blinks twice, then release Setup.
3. Enter 9- 9 - 0.
4. To view the code for the first digit,press 1once.
Wait 3 seconds and count the number ofLED
blinks (e.g.,3 blinks = 3) and write down
the number in the leftmost TV Code box on
page 12.
NOTE:If a code digit is “0”,the LED will not blink.
5. Repeat step 4 three more times for remaining
digits.Use 2for the second digit,3for the third
digit,and 4for the fourth digit.Finish writing
down the code in the TV Code boxes (on
page 12).
6. To check for other device codes,repeat steps 1 to
5,but substitute the appropriate key (i.e.,VCR,
AUX,or SAT) for the device you are checking.
Write down the codes in the appropriate boxes
on pages 10 and 12.
DirecTV Mnl MDTV6 3/21/03 2:04 PM Page 24