INSTALLING BATTERIES
The DIRECTV®Universal Remote Control comes with
preinstalled batteries.To activate them,pull the tab out
ofthe battery case.To change the batteries,perform the
following steps:
NOTE:The DIRECTV Universal Remote Control will stop
operating when the batteries are fully drained.Replacing the
batteries will restore your DIRECTV Universal Remote Control
to its full functionality, complete with your favorite set tings.
1. On the back ofthe remote control,push the
latch (as shown),lift off the battery cover,and
remove the used b atteries.
2. Obtain two (2) new AA alkaline batteries.
Match their + and – marks to + and – marks
in the battery case,then insert them.
3. Align the cover’s tabs with the case’s holes.
Press down on the cover until the latch locks.
4. Test the remote control by pressing Power and
any device key (e.g.TV,VCR,AUX,or SAT).Ifthe
batteries are inserted correctly,the selected
device key will blink once.
8