Chapter 2
Receiver Description and Installation
Programming the Recover Button
Your remote controls come equipped with a RECOVER button that helps you if you accidentally change the channel or video input on your remote TV and cannot get the picture back from your satellite receiver. When you press the RECOVER button as described on page 56, the remote control sends commands to your remote TV to change channels or video inputs to try to get you back to watching satellite programming.
When your Remote Control 2 is shipped from the factory, the RECOVER button is set up to restore satellite TV viewing by tuning your TV to channel 3, 4, and other inputs (see page 56 for details). However, to use the RECOVER button with your remote TV, you need to program the RECOVER button with the specific channel (for example, channel 60) that you use to watch TV2 programming. The following instructions describe how to program the RECOVER button to tune your remote TV back to a selected channel.
Programming the Recover Button Channel
1.Program Remote Control 2 to control your remote TV using the instructions in Control Other Devices with the Remote Controls on page 106.
2.Press and hold the TV mode button until all the other mode buttons light up, and then let go of the button. The TV mode button flashes.
3.Press the STAR (*) button.
4.Enter the three digits of your channel number. For example, if your remote TV is set to channel 60, enter
5.Press the POUND (#) button. The TV mode button flashes three times.
Removing the Recover Button Channel Programming
The following instructions describe how to reset the RECOVER button to the way it was delivered to you from the factory.
1.Press and hold the TV mode button until all the other mode buttons light up, and then let go of the button. The TV mode button flashes.
2.Press the STAR (*) button.
3.Press
4.Press the POUND (#) button. The TV mode button flashes three times.
Page 36
