Chapter 2
Receiver Description and Installation
Setting Up TV1 to Operate in UHF Pro
You can set your receiver to operate your TV1 using another UHF Pro remote control (sold separately) by completing the following instructions:
If you set up your receiver to operate the 
side using UHF Pro, the two UHF Pro remotes for this receiver will interfere with each other when operated at the same time. This may prevent the remotes from operating the receiver momentarily.
1.Perform the following using an existing remote control:
a.Open the TV1 UHF Pro Setup screen by pressing
b.Select Enable from the TV1 UHF Pro Setup screen.
c.Select System Info to open the System Information screen.
d.Move the highlight to the address for the Primary Remote Address as shown below. This is important - if you do not do this, your remote will change the receiver's Secondary Remote Address and cause your Remote Control 1 to control the 
side of your receiver.
Note: Highlight the
Primary Remote
Address.
2.Perform the following using the UHF Pro remote that you are going to use to control TV1:
a.Press and hold the SAT mode button about three seconds, until all the mode buttons light up, and then let go of the SAT button. The SAT mode button will blink.
b.Use the NUMBER PAD buttons to enter any number from 1 to 16, except for the number shown by the Secondary Remote Address. The SAT mode button goes out after you enter each digit, and then lights up again.
Write down the number you entered:
c.Press the POUND (#) button. If you entered the address correctly, the SAT mode button will flash three times.
d.Press the RECORD button.
e.Make sure the System Information screen shows that the Primary Remote Address shows 
UHF Pro and IR and that this address matches the number you entered in step b.
Page 46
