Dixon 966412801, 115 239947 manual Operation, Tips for Improved Bagging

OPERATION

TIPS FOR IMPROVED BAGGING

Follow the mower operation instructions in you mower operator’s manual.

When operating your grass catcher on a lawn where grass and leaf bagging equipment has not been used, you are picking up thatch and debris that has accumulated for long periods of time. The amount collected and the total time of operation may be greater than you will experience with regular use of your grass catcher.

•Always run throttle at full speed when bagging.

•Select a speed low enough to give good mower cutting performance, good quality cut and good bagging performance.

NOTE: It may be necessary to overlap width of cut to suit your conditions.

•If grass is extremely tall, it should be mowed twice. The first time relatively high, the second time to desired height.

•Use left hand side of mower for trimming.

•Plastic trash bags (3.0 mil, 30 gallon) can be inserted inside grass catcher containers for ease of debris disposal. To remove the plastic trash bags when full:

a.Disengage blades, shift into neutral, engage the parking brake and stop the engine.

b.Unlatch and raise cover.

c.Remove one container at a time by grasping container handles and pulling toward the rear, off of the tube rails.

d.With the container resting on the ground, close and secure the top of the plastic lawn bag.

e.Tip the container on its side and slide the filled bag from the container.

f.Install a new plastic lawn bag with the edges of the bag draped over upper lip of the Container (for replacement bags refer to

REPLACEMENT PARTS).

g.Repeat for other container.

h.Reinstall containers making sure right container overlaps left container at center supports.

i.Close cover and secure latches over center support tubes.

•Avoid cutting wet grass or in the morning while the dew is still heavy. Grass clippings collected under these conditions tend to be sticky and adhere to the walls of the flow path causing clogging.

•If the grass catcher fails to pick up cut grass or leaves, it is an indication that clogging has occurred in the system or that the grass catcher containers are full.

a.Disengage blades, place motion control levers in neutral position.

-Unlatch and raise cover.

-Slide out containers and dispose of clippings.

-Replace containers, close cover, and latch.

b.Unlatch chutes and check for clogging.

-Remove all debris in chute.

-Reassemble and latch chutes.

GENERAL RECOMMENDATIONS

Always observe safety rules when performing any maintenance.

•Before each use check for loose fasteners.

•Clean unit thoroughly after each use.

BLADE CARE

•For best results mower blades must be kept sharp. Replace bent or damaged blades.

•See BLADE CARE instructions in your mower operator’s manual.

CAUTION

BEFORE PERFORMING

MAINTENANCE, SERVICE OR

ADJUSTMENTS:

•Set parking brake.

•Place motion control levers in “NEUTRAL” position.

•Place clutch control in “DISENGAGED” position.

•Turn ignition key to “OFF” position.

•Make sure blades and all moving parts have completely stopped.

•Disconnect spark plug wire(s) from spark plug(s) and place wire where it cannot come in contact with plug.

10