Dixon 968999515 manual FRONT WEIGHTS See Figure, Assembly

Models: 968999515

1 20

Page 10

ASSEMBLY

(See Figure 8)

CAUTION

DO NOT operate mower with grass catcher, unless the front weights are installed.

1.Remove foot rest from the front of the mower.

2.Remove the two (2) front bolts that secure the caster casting to the sides of the frame.

3.Remove the two (2) bolts that secure the caster castin to the bottom of the frame.

4.Place weight bracket on the front of the frame.

5.Secure the weight bracket to the frame with the four (4) previously removed bolts.

6.Install weight to the weight bracket with two

(2)bolts (539990588) and two (2) nuts (539976979).

7.Install foot rest on the weight bracket with six

(6)(539113183 and two (2) (539113182) screws.

NOTE: the shorter screws go in the center.

FOOT REST

PREVIOULY REMOVED HARDWARE

539113177 (CAST WEIGHT)

539113183

(SCREW #10-12 X 1 1/4)

539113182 (SCREW #10-12 X 1)

539976979

(NUT, 3/8-16, NYLOC)

539113225 (WEIGHT BRACKET)

539990588

(BOLT, 3/8-16 X 2, GR5) FIGURE 8

Image 10

Contents

MANUAL NO. 539 113943 REV. IR 01/23/07 Grass CatcherFor 48 Inch and 54 Inch Operator And Parts ManualI. GENERAL OPERATION SAFETY RULESDANGER II. SLOPE OPERATIONDO NOT IV. SERVICEIII. CHILDREN NEVER allow children to operate the machineLook for this symbol to point out impor- tant safety precautions. It means CAU- TION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED SAFETY RULESSAFE OPERATION PRACTICES FOR RIDE-ON MOWERS TABLE OF CONTENTS KNOW YOUR GRASS CATCHERUNPACKING INSTRUCTIONS TOOLS REQUIRED FOR ASSEMBLYCARTON CONTENTS PARTS IDENTIFICATION1 BAGGER SUPPORT ASSEMBLY See Figures 1A and 1B ASSEMBLY2 MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY See Figure FIGURE 1A4 CONTAINER MOUNTING See Figure 3 CONTAINER ASSEMBLY See FigureASSEMBLY 7 LEVEL MOWER DECK 5LOWER CHUTE See Figure6 UPPER CHUTE See Figures 6A & 6B FIGURE 6A8 FRONT WEIGHTS See Figure ASSEMBLYTIPS FOR IMPROVED BAGGING OPERATION DO NOT operate mower with grass catcher partially installedOPERATION Close cover before startingGENERAL RECOMMENDATIONS BEFORE PERFORMING ANY MAINTE- NANCE, SERVICE OR ADJUSTMENTSCUSTOMER RESPONSIBILITIES BLADE CAREPARTS ILLUSTRATION PARTS Screw, #10-14 x 1/2, special PARTSDESCRIPTION Washer, 3/16 x 3/4 x 16 GaPARTS DESCRIPTION PARTSScrew, #10-12 x 1 1/4, wash hd U.S. Standard Hardware TORQUE SPECIFICATIONSHEX HEAD CAP SCREWS Metric Standard HardwarePage HTC 401 N. Commerce St Beatrice, NE