ASSEMBLY
3 CONTAINER ASSEMBLY (See Figure 3)
1.Place bottom half inside of top half, as shown.
2.Place one foot inside bottom half and lift top half to meet bottom half.
3.Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN IN IN- SET.
4. Repeat for other containers.
CONTAINER
BOTTOM
HALF
4 CONTAINER MOUNTING (See Figure 4)
1.Install one container to left side first with warning to the outside of unit. Install another container to center position and one in right position.
NOTE: Right container should always overlap left container at center supports.
2.Close cover and lock latch handles over center support tubes.
COVER LATCH
HANDLES
CONTAINER
WARNING
CONTAINER BOTTOM HALF
CONTAINER
TOP HALF
PRESS TOGETHER TO FORM SEAL WHILE LIFTING TOP HALF
CENTER
SUPPORT
TUBES
CONTAINER | CONTAINER |
HANDLE | WARNING |
WARNING
LOCKING
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of container and check that there is no gap be- tween upper and lower halves. If a gap appears, unlock tabs to separate container halves and re- peat instructions above.
FIGURE 3
DO NOT operate mower unless container is properly installed. Container is subject to wear and deterioration, check contain- ers frequently, replace when cracked or damaged. Use only a recommended re- placement container.
FIGURE 4
8
