MAINTENANCE
V-belts
Check every 100 hours of operation. Check for severe cracking and large nicks.
NOTE: The belt will show some small cracks in normal operation.
The belts are not adjustable. Replace belts if they begin to slip from wear.
Deck Belt
1. | Park on a level surface. Apply parking brake. |
|
2. | Lower the deck into the lowest cutting |
|
| position. |
|
3. | Remove bolts from belt shields and remove |
|
| shields. |
|
4. | Remove any dirt or grass that may have | Remove belt shields |
| accumulated around the cutter housings and |
|
| entire deck surface. |
|
5.Carefully roll the belt over the top of the cutter housing pulleys and remove belt.
Deck belt installation
NOTE: For ease in installing the deck belt, refer to the routing decal on bottom of seat.
1.Wrap the deck belt around the electric clutch pulley that is located on the engine shaft.
2.Route the belt forward and up onto the deck.
3.Place belt around spring loaded idler pulley.
4.Wrap the belt around the stationary idler pulley and around the mandrel housings.
5.Push inward on the idler arm and carefully route belt over stationary idler pulley. Once belt is properly routed, slowly release idler arm to tension belt.
6.Double check belt routing to make sure it matches the routing decal, and the belt does not have any twist. Correct as needed.
7.Replace belt shields on both mandrel housings and secure with fasteners.
1
2
1.Clutch pulley
2.Deck belt
Belt routing, deck belt
39
